Renseignements généraux

Nº de série

S/O

Nº de partie

1

Nombre total de parties

1

Ou

S/O

Brevets

S/O

Description générale

Dull silver metal cap & locking pin; clear glass shell; ceramic liner.

Dimensions

Remarque : Cette information reflète la taille générale pour l’entreposage et ne représente pas nécessairement les véritables dimensions de l’objet.

Longueur

S/O

Largeur

S/O

Hauteur

23,0 cm

Épaisseur

S/O

Poids

S/O

Diamètre

25,5 cm

Volume

S/O

Lexique

Groupe

Énergie-électrique

Catégorie

Transmission et distribution

Sous-catégorie

S/O

Fabricant

Ou

Sediver

Pays

Chine

État/province

Inconnu

Ville

Shanghai

Contexte

Pays

Canada

État/province

Ontario

Période

This type made c. 2008, and used until 2010. This example appears new/unused.

Canada

The [lot] donation includes insulators, dampers, conductors, a preform rod, a sign, and personal gear from a Hydro One transmission station. It shows choices made by Hydro One, the typical equipment used at the beginning of the 21st c. on high voltage lines in Ontario. The artifacts also represent diversity and the longevity of manufacturers of electrical equipment and globalization of the markets. [Ref. 1]

Fonction

Used in electrical power transmission to separate conductors to prevent a flow of current between them or to other objects.

Technique

Insulators are designed to be used with lines of a specific voltage: in Ontario, the voltage is usually 115kV; 230 kV and 500 kV. The insulators are assembled in sequences; the number of insulators in a sequence indicates the kV of the transmission line. Iron caps and locking keys allow attaching one insulator to another. Insulators such as this example would be used in sequence with CSTM 2020.0145.1 on 500kV line. Glass insulators are once more gaining popularity. Since the late 1980s, polymeric insulators have been promoted by manufacturers as a superior technology. Hydro One is now going back to glass insulators. Even though they are much heavier then polymeric insulators, glass insulators are more durable and have lower rate of failure. Moreover, to diagnose a potential failure of a polymeric insulator, the lineman has to climb to the top of the pylon and use testing equipment. Glass insulators break to pieces and linemen can see the problem from the ground. This saves time, is more cost efficient and safer. Many insulators suffer from critical surface cracks. The Sediver glass is pre-stressed under very high pressure to ensure that the formation of the cracks is minimized. Dielectric (non-conducting) shells are made from very structurally pure glass and are durable and resilient to environmental wear. The cap & pin are also made from dielectric materials; their long term mechanical performance depends on their ability to resist the internal cracks due to stress in service. The electrical performance of these materials is similarly dependant on their structural consistency. Internal fracture is the starting point of failure due to electrical stress concentration.

Notes sur la région

Inconnu

Détails

Marques

" 11" and "U70FN04/ 15000 LBS/ M.E. 268" cast in raised print on one side of cap; "230" and "EIV 85/ 7500 LBS/ TEST" cast in raised print on opposite side. "M" stamped into cap. "30" cast in raised print on edge of glass shell.

Manque

Appears complete.

Fini

Dull silver metal cap & locking pin; green glass shell; ceramic liner.

Décoration

S/O