Renseignements généraux

Nº de série

103018

Nº de partie

1

Nombre total de parties

6

Ou

S/O

Brevets

S/O

Description générale

ALL METAL CONSTRUCTION. FORMS AND CARBON COPY (PTS) ARE PAPER.

Dimensions

Remarque : Cette information reflète la taille générale pour l’entreposage et ne représente pas nécessairement les véritables dimensions de l’objet.

Longueur

39,0 cm

Largeur

27,0 cm

Hauteur

9,0 cm

Épaisseur

S/O

Poids

S/O

Diamètre

S/O

Volume

S/O

Lexique

Groupe

Imprimerie

Catégorie

Duplication

Sous-catégorie

S/O

Fabricant

Ou

STANDARD

Pays

United States of America

État/province

Ohio

Ville

Dayton

Contexte

Pays

Canada

État/province

Ontario

Période

THIS TYPE OF FORM REGISTER USED IN 1930S +

Canada

FROM 1934 UNTIL 1989 STANDARD REGISTER OF DAYTON OHIO & R.L. CRAIN OF OTTAWA ENJOYED A LONG & SUCCESSFUL BUSINESS ASSOCIATION. THIS ASSOCIATION PERMITTED CRAIN TO USE MANY OF STANDARD REGISTER'S TECHNOLOGIES, AND TO SELL THEIR PRODUCTS & SERVICES IN CANADA. (REF. 1)

Fonction

TO PRECISELY ALIGN 2 OR MORE FORMS, IN ORDER TO DUPLICATE EXACTLY THE INFORMATION CONTAINED THEREON.

Technique

STANDARD REGISTER CO. WAS FOUNDED IN DAYTON, OHIO IN 1912 AND SHORTLY THEREAFTER INTRODUCED THE 'AUTOGRAPHIC REGISTER'. CONTINUOUS FORMS PUNCHED ALONG BOTH MARGINS WERE FED THROUGH THE DEVICE BY MEANS OF SPROCKET WHEELS WITH PINS: UP TO 8 COPIES COULD BE PRODUCED AT ONE TIME. THE DEVICE SIMPLIFIED BUSINESS TRANSACTIONS AND QUICKLY BECAME THE STANDARD. (REF. 1)

Notes sur la région

Inconnu

Détails

Marques

"Standard/ THE STANDARD REGISTER CO.- DAYTON, OHIO" printed in gold on one side of register casing. "T1", "MADE IN U.S.A." and "103018" incised on inside front edge. Label fixed to inside upper edge of register top reads "LOADING INSTRUCTIONS FOR TABLET REGISTER/ Raise lid by placing left hand in the register opening against writing table, to hold paper and carbon, and lift lid/ at back./ Place pack in space under writing table. (Pack must not be over 3/4" high.) All forms pass over the one idler/ back of writing table./ Thread forms between the carbon shield holders./ The shields span the carbon sheets and prevent paper folds catching on carbon./ Then load forms over pin wheels./ The lid is then dropped in place and machine is ready to issue forms. A tray attached under register is/ provided to hold issued forms./ If carbon sheets are not held while raising lid, they will be displaced from between shields and should be/ properly rearranged./ H-2496-5-2-32. Printed by The Standard Register Co., Dayton, Ohio, U.S.A.". "Lap Over Carbon" printed on top linen leaf strip; "Lap Under Carbon" printed on bottom sheet./ PT forms: Forms are numbered. Each form marked " H-939 Printed by The Standard Register Co., Dayton, Ohio, U.S.A. " in lower right edge of front.

Manque

NONE, SAVE POSSIBLY ONE END PIECE ON ROLLER.

Fini

BLACK INTERIOR & EXTERIOR FINISHES/ PT: FORM PAD IS OFF-WHITE.

Décoration

S/O